Series K-20-15

Description

7 in 1" kit in the tried-and-tested KUKKO-L-Boxx system.
The set facilitates the assembly of seven different puller models through the combination of separators, mechanical and hydraulic spindles, pulling jaws and extensions.
Pulling hook with quick adjusting capability quick adjust.
Jaw extensions.
Parallel pulling hooks in every position, even with full load.
Pulling hooks with infinitely variable adjustment on the cross-beam.
Hydraulic and mechanical pressure screw.
Milled thread treated with special coating.
The sharp blades enable flush parts to be removed where pulling jaws cannot be used.
Includes a pressure pad set for supporting the pressure spindle in a hollow shaft.
Instructions on the cover.
Secure storage in special foam.
Personal KUKKO-Chip-Code.

Practical package for universal use.
Easy and even pulling for particularly tight parts.
A manual adjustment knurl allows rapid loosening and adjusting of the extractor jaws on the cross-beam without using a wrench.
Variable reach with jaw extensions.
Optional conversion to various jaw types for mechanical use.
Turning the pulling hooks enables them to be used both internally and externally.
Suitable for pulling asymmetric workpieces.
Cross-beams with hexagonal profile for good grip.
Hydraulic spindle can be used for both cross-beams.
Spindle head band prevents the wrench from slipping off.
Almost all components available as replacement parts, time-saving order process thanks to numbering system.
Complete easy-to-manage package.
KUKKO-L-Boxx-System compatible with systems by all common manufacturers.

Quality made in Germany.
Strong design, high performance and long service life.
Self-healing corrosion protection KUKKoating for galvanized parts (WITHOUT chrom VI).
Safety label to ensure protection of intellectual property.
A tube of KUKKO special grease included for pressure spindle.

The pulling hooks' sliding parts must always sit stably and fully on the cross-beam.
If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
The pulling hooks' support surfaces must always be straight and sit fully beneath the part to be removed.
Observe max. torque.
Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
Protective blanket required.
Protective goggles required.

metricimperial